Reference Guide

Related
Commands
dampening — configures dampening on an interface.
show interfaces — displays information on a specific physical interface or virtual
interface.
show interfaces configured — displays any interface with a non-default
configuration.
show interfaces phy
Display auto-negotiation and link partner information.
Syntax
show interfaces gigabitethernet slot/port phy
Parameters
tengigabitether
net
Enter the keyword tengigabitethernet then the slot or
port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
6.5.4.0 Introduced on the E-Series.
Usage
Information
The following describes the show interfaces gigabitethernet command
following example.
Mode Control Indicates if auto negotiation is enabled. If so, indicates
the selected speed and duplex.
Mode Status Displays auto negotiation fault information. When the
interface completes auto negotiation successfully, the
838
Interfaces