Reference Guide

• IPv4
• IPv6
• MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot
be enabled simultaneously.
Example (Single
Range)
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
Commands
interface — configures a physical interface.
interface loopback — configures a loopback interface.
interface null — configures a null interface.
interface port-channel — configures a port channel group.
show vlan — displays the current VLAN configuration on the switch.
shutdown — disables/enables the VLAN.
tagged — adds a Layer 2 interface to a VLAN as a tagged interface.
untagged — adds a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Interfaces
815