Reference Guide

Version Description
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to 10 Mbps or 100 Mbps, you can also execute the duplex
command.
Related
Commands
negotiation auto — enables or disables auto-negotiation on an interface.
duplex (Management interface)
Configure duplex mode on a management interface whose speed is set to 10/100 Mb/s.
S5000
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half Enter the keyword half to set the physical interface to
transmit only in one direction.
full Enter the keyword full to set the physical interface to
transmit in both directions.
Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
This command applies only to management interfaces with speed set to 10/100
Mb/s using the speed command.
NOTE: When you set the speed to 10 or 100 Mbps, you can also execute the
duplex command.
798
Interfaces