Reference Guide

show ip igmp snooping groups
Display snooping related information for all the IGMP groups, interface or one group of one interface.
S5000
Syntax
show ip igmp snooping groups [group-address [detail] | detail |
interface [group-address [detail]]]
Parameters
snooping Enter the keyword snooping to display snooping related
information.
group-address (OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
interface (OPTIONAL) Enter the interface type and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
detail (OPTIONAL) Enter the keyword detail to display the
IGMPv3 source information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, Z9000,
and Z9500.
Usage
Information
This command displays the IGMP database, including configured entries for either
all groups on all interfaces, all groups on specific interfaces, or specific groups on
specific interfaces.
The following describes the show ip igmp groups command shown in the
following example.
Internet Group Management Protocol (IGMP)
787