Reference Guide

Version Description
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.7.1.0 Introduced on the E-Series.
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
in the IGMP groups. You may not use extended access lists with this command.
When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard — creates a standard access list to filter based on IP address.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
S5000
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Changed the default IGMP from version 2 to version 3.
Introduced on the S6000-ON
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
774
Internet Group Management Protocol (IGMP)