Reference Guide

Version 8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy
run start) then reload the system for the new settings to take effect.
There are four groups total. You must allocate at least one group for L2ACL and
IPv4 ACL.
The range for the CAM profiles are 1 to 4 for l2acl. The range for the ipv6acl
profile is 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
Syntax
cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Content Addressable Memory (CAM)
587