Reference Guide

Version Description
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage
Information
Save the new CAM settings to the startup-config (write-mem or copy run
start
) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. Only 13 number of blocks can be
configured by the user .
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the command reload
conditional nvram-cfg-change.
cam-acl-egress (Configuration)
Select the FP groups for CAM access control lists for Layer 2, IPv4, and IPv6 ACLs.
Syntax
cam-acl-egress {default | l2acl number ipv4acl number ipv6acl
number}
Parameters
default Reset the egress CAM ACL entries to the default settings.
l2acl number
ipv4acl number
ipv6acl number
Allocate space to each CAM region.
Enter the CAM profile name followed by the amount of CAM
space to be allotted. The total space allocated must equal 13.
The l2acl range is 1 to 4. The ipv4acl range is 1 to 4. The
ipv6acl range is 0 to 4.
Command
Modes
CONFIGURATION
Command
History
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
586
Content Addressable Memory (CAM)