Reference Guide

Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.1(0.0) Deprecated command. Replaced by the stop bmp
command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.4 Introduced on the Z9000.
Version 8.3.10.1 Introduced for the S4810.
Usage
Information
Use the stop jumpstart command on a switch running BMP 2.0 if the switch
enters a loop while reloading in jumpstart mode; loop occurs when the switch is
continuously trying to contact a DHCP server and a DHCP server is not found. The
stop jumpstart command stops the switch from connecting to the DHCP
server. After you use the stop jumpstart command, the next default reload type
is a normal reload. This is indicated in the
show reload-type command.
Related
Commands
reload type — configures the reload mode as normal or jumpstart (BMP).
Bare Metal Provisioning (BMP)
581