Reference Guide

Parameters
regex Enter a regular expression.
Defaults Not configured.
Command
Modes
CONFIGURATION (conf-ext-community-list)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
Duplicate commands are silently accepted.
Example
Dell(conf-ext-community-list)#permit regexp 123
Dell(conf-ext-community-list)#
Related
Commands
deny regex — denies a community using a regular expression.
set extcommunity rt
To set Route Origin community attributes in Route Map, use this feature.
Syntax
set extcommunity rt {as4 ASN4:NN [non-trans] | ASN:NNNN [non-
trans] | IPADDR:NN [non-trans]} [additive]
To delete the Route Origin community, use the no set extcommunity
command.
Parameters
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific
extended community number in the format ASN4:NN (4-
byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number
in the format ASN:NNNN (2-byte AS number:4-byte
community value).
IPADDR:NN Enter the IP address specific extended community in the
format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte
community value).
570
Border Gateway Protocol