Reference Guide

Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
When you enable the bgp non-deterministic-med command, the show ip
bgp command output for a BGP route does not list the INACTIVE reason.
The following describes the show ip bgp ipv4 multicast command shown
the Example below.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the
destination network.
Example
Dell#show ip bgp ipv4 multicast
BGP table version is 14, local router ID is 100.10.10.1
Status codes: s suppressed, S stale, d damped, h history, *
valid, > best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*>I 25.1.0.0/16 25.25.25.25 0 100 0 i
*>I 25.2.0.0/16 25.25.25.26 0 100 0 ?
*>I 25.3.0.0/16 211.1.1.165 0 100 0 ?
*>r 144.1.0.0/16 0.0.0.0 0 32768 ?
*>r 144.2.0.0/16 100.10.10.10 0 32768 ?
*>r 144.3.0.0/16 211.1.1.135 0 32768 ?
*>n 145.1.0.0/16 0.0.0.0 0 32768 i
Dell#
Related
Commands
show ip bgp community – views the BGP communities.
552
Border Gateway Protocol