Reference Guide

• set origin
• set weight
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
Dell Networking OS software resolves the network address configured by the
network command with the routes in the main routing table to ensure that the
networks are reachable using non-BGP routes and non-default routes.
Related
Commands
redistribute – redistributes routes into the BGP.
redistribute
Redistribute routes into BGP.
C-Series, E-Series TeraScale, S-Series
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map map-name] command.
Parameters
connected Enter the keyword connected to redistribute routes from
physically connected interfaces.
static
Enter the keyword static to redistribute manually
configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the
name of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
Border Gateway Protocol
549