Reference Guide

Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
The first time you enter this command, it configures the neighbor as a route
reflector and members of the route-reflector cluster. If you configure a route
reflector, internal BGP (IBGP) speakers do not need to be fully meshed.
When you disable all clients of a route reflector, the neighbor is no longer a route
reflector.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
C-Series, E-Series TeraScale, S-Series
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map
map-name] command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the
name of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
548
Border Gateway Protocol