Reference Guide

If the Route map is not configured, the default is deny (to
drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route
reflector configuration, use the no neighbor ip-address | peer-group-
name
route-reflector-client command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Defaults Not configured.
Border Gateway Protocol
547