Reference Guide

If the AS-PATH access list is not configured, the default is
permit (allow routes).
in Enter the keyword in to filter inbound BGP routes.
out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command
Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
Usage
Information
Use the ip as-path access-list command in CONFIGURATION mode to
enter AS-PATH ACL mode and configure the AS-PATH filters to deny or permit BGP
routes based on information in their AS-PATH attribute.
Related
Commands
ip as-path access-list – enter AS-PATH ACL mode and configure the AS-PATH
filters.
neighbor maximum-prefix
Control the number of network prefixes received.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-
group-name} maximum-prefix maximum command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the E-Series software
sends a message. The range is 1 to 100 percent. The default
is 75.
544
Border Gateway Protocol