Reference Guide

ipv6 unicast (OPTIONAL) Enter the keyword ipv4 followed by the
keyword unicast to view dampened-route information
related only to ipv6 unicast routes.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
b
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced IPv6 MGBP support for the E-Series.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
S5000
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4
[multicast | unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
reset the peer group corresponding to that VRF.
NOTE: You can use this attribute on a specific VRF to
remove history routes corresponding to that VRF. You
can also use this attribute to return the suppressed
routes corresponding to a specific VRF to an active state.
peer-group-
name
Enter the peer group name to reset the BGP sessions within
that peer group.
Border Gateway Protocol
537