Reference Guide

Related
Commands
ip as-path access-list — enter AS-PATH ACL mode and configure the AS-PATH
filters.
neighbor graceful-restart
Enable graceful restart on a BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} graceful-restart
[restart-time seconds] [stale-path-time seconds] [role
receiver-only]
To return to the default, enter the no bgp graceful-restart command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to apply the filter to all
routers in the peer group.
restart-time
seconds
Enter the keyword restart-time then the maximum
number of seconds to restart and bring-up all the peers. The
range is from 1 to 3600 seconds. The default is 120 seconds.
stale-path-time
seconds
Enter the keyword stale-path-time then the maximum
number of seconds to wait before restarting a peer’s stale
paths. The default is 360 seconds.
role receiver-
only
Enter the keyword role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults as above
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
460
Border Gateway Protocol