Reference Guide

Version 7.5.1.0 Introduced
Related
Commands
capture bgp-pdu neighbor — enables capture of an IPv4 BGP neighbor packet.
show capture bgp-pdu neighbor — displays BGP packet capture information for an
IPv6 address.
capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address
command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced.
428
Border Gateway Protocol