Reference Guide

max-suppress-
time
(OPTIONAL) Enter the maximum number of minutes a route
can be suppressed. The default is four times the half-life
value. The range is from 1 to 255. The default is 60 minutes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Only match commands in the configured route map are
supported.
Defaults Disabled.
Command
Modes
• ROUTER BGP
• ROUTER BGP-address-family
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
If you enter the bgp dampening command, the default values for half-life,
reuse, suppress, and max-suppress-time are applied. The parameters are
position-dependent; therefore, if you configure one parameter, configure the
parameters in the order they appear in the CLI.
Route refresh is sent when you enable BGP dampening.
Related
Commands
show ip bgp dampened-paths — views the BGP paths.
Border Gateway Protocol
415