Reference Guide

source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or noncontiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a host
IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
count (OPTIONAL) Enter the keyword count to count packets that
the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes that the
filter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to enter
ACL matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP
DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword
order, the ACLs have the lowest order by default
(255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
fragments Enter the keyword fragments to use ACLs to control packet
fragments.
Defaults Not configured.
Command
Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
246
Access Control Lists (ACL)