Reference Guide

VLT NDP Statistics
--------------------
NDP NA VLT Tunnel Pkts sent:16
NDP NA VLT Tunnel Pkts Rcvd:46
NDP NA Non-VLT Tunnel Pkts sent:0
NDP NA Non-VLT Tunnel Pkts Rcvd:0
Ndp-sync Pkts Sent:144
Ndp-sync Pkts Rcvd:105
Ndp Reg Request sent:25
Ndp Reg Request rcvd:24
show vlt mismatch
Display mismatches in VLT parameters.
Syntax
show vlt mismatch
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced the support for Q-in-Q implementation over
VLT on the S-Series and Z-Series.
9.5(0.0) Introduced on the Z9500.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
Example
Dell#show vlt mismatch
Domain
-------
Parameters Local Peer
---------- ----- -----
Unit-ID 0 1
Vlan-config
------------
Vlan-ID Local Mode Peer Mode
------- ---------- ---------
100 -- L3
Vlan IPV4 Multicast Status
Virtual Link Trunking (VLT)
2055