Reference Guide

sp-tag-dot1p
value
Enter the keyword sp-tag-dot1p then the service provider
dot1p value. The range is from 0 to 7.
Defaults none
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN
tag). If you do not configure this command, Dell Networking OS assigns the value 0x9100.
Syntax
vlan-stack protocol-type number
Parameters
number Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The
range is from 0 to FFFF. The default is 9100.
Defaults 0x9100
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
2016
VLAN Stacking