Reference Guide

stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-unit number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch with
the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Defaults 0
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related
Commands
• reload – reboots Dell Networking OS.
stack-unit renumber
Change the stack member ID of any stack member or a stand-alone unit.
Syntax
stack-unit 0-11 renumber 0-11
Parameters
0-11 The first instance of this value is the stack member unit
identifier, from 0 to 11, of the switch that you want add to
the stack. The range is: 0 to 11. The second instance of this
value is the desired new unit identifier number.
Defaults none
Stacking Commands
1955