Reference Guide

• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
priority (OPTIONAL) Enter the priority used in Bootstrap election
process. The range is zero (0) to 255. The default is 192.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the S-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
ip pim snooping
Enable PIM-SM snooping globally on a switch or on a VLAN interface.
Syntax
ip pim snooping [enable]
To disable PIM-SM snooping, use the no ip pim snooping [enable]
command.
Defaults Disabled.
Command
Modes
• CONFIGURATION: To configure PIM-SM snooping globally, enter the ip pim
snooping enable
command in global configuration mode.
• VLAN INTERFACE: To configure PIM-SM snooping on a VLAN interface, enter
the ip pim snooping command in VLAN interface configuration mode.
PIM-Sparse Mode (PIM-SM)
1603