Reference Guide

PIM-Sparse Mode (PIM-SM)

The protocol-independent multicast (PIM) commands are supported by the Dell Networking operating

software on the platform.

IPv4 PIM-Sparse Mode Commands

The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.

clear ip pim snooping tib

Clear tree information discovered by PIM-SM snooping from the PIM database.

Syntax

clear ip pim snooping tib [vlan vlan-id] [group-address]

Parameters

vlan vlan-id (OPTIONAL) Enter a VLAN ID to clear tree information base

(TIB) information learned through PIM-SM snooping about a

specified VLAN. The valid VLAN IDs are 1 to 4094.

group-address (OPTIONAL) Enter a multicast group address in dotted

decimal format (A.B.C.D) to clear TIB information learned

through PIM-SM snooping about a specified multicast group.

Command

Modes

EXEC Privilege

Command

History

Version Description

8.4.1.1 Introduced on the E-Series ExaScale.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

Commands

show ip pim snooping tib – displays TIB information learned through PIM-SM

snooping.

1588

PIM-Sparse Mode (PIM-SM)