Reference Guide

Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or
enter a number from zero (0) to 65535.
no-summary (OPTIONAL) Enter the keywords no-summary to prevent the
ABR from sending summary Link State Advertisements (LSAs)
into the stub area.
Defaults Disabled.
Command
Modes
ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
To configure all routers and access servers within a stub, use this command.
Related
Commands
router ospf — enters ROUTER OSPF mode to configure an OSPF instance.
area virtual-link
Set a virtual link and its parameters.
C-Series, E-Series, S-Series
Syntax
area area-id virtual-link router-id [[authentication-key
[encryption-type] key] | [message-digest-key keyid md5
[encryption-type] key]] [dead-interval seconds] [hello-interval
seconds] [retransmit-interval seconds] [transmit-delay seconds]
Open Shortest Path First (OSPFv2 and OSPFv3)
1459