Reference Guide

=======================================================
Switch Zoning Parameters
=======================================================
Default Zone Mode: Deny
Active Zoneset: None
=======================================================
Members
Fc 0/0 Fc 0/1 Fc 0/2 Fc 0/3 Fc 0/4 Fc 0/5 Fc 0/6 Fc 0/7 Fc 0/8
Fc 0/9 Fc 0/10 Fc 0/11
=======================================================
=======================================================
Dell#
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
fc zoneset — creates a zoneset.
show npiv devices
Display the FCoE and FC devices currently logged in to an S5000 NPIV proxy gateway.
S5000
Syntax
show npiv devices [brief]
Parameters
brief Displays an overview of current server CNA-fabric
connections over an S5000 NPIV proxy gateway.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
Use the show npiv devices command to display information on the server CNA,
server-facing Ethernet and fabric-facing FC ports, and the SAN fabric in each
server-fabric connection over an S5000 NPIV proxy gateway.
The following table describes the show npiv devices brief output shown in
the example below.
Field Description
ENode-Intf S5000 Ethernet interface (slot/port) to which a server CNA is
connected.
NPIV Proxy Gateway
1449