Reference Guide

fabric-id vlan
In an FCoE map, configure the association between the dedicated VLAN used to carry FCoE traffic
between servers and a SAN, and the fabric where the desired storage arrays are installed.
S5000
Syntax
fabric-id fabric-num vlan vlan-id
Parameters
fabric-id
fabric-num
Enter a fabric ID number that is the same as the ID number
of the dedicated VLAN used to carry FCoE storage traffic to
the fabric specified in the FCoE map.
vlanvlan-id Enter the ID number of the dedicated VLAN used to carry
FCoE storage traffic between servers and a SAN fabric and
specified with the vlan command in the FCoE map.
Defaults None
Command
Modes
FCOE MAP
Command
History
Version 9.0(1.3) Introduced on the S5000.
Usage
Information
In the fabric-id vlan command, the fabric and VLAN ID numbers must be the
same.
In each FCoE map, the fabric ID, FC-MAP value, and FCoE VLAN parameters must
be unique.
To remove a fabric-VLAN association from an FCoE map, enter the no fabric-id
vlan
command.
Related
Commands
fcoe-map — creates an FCoE map which contains the parameters used in the
communication between servers and a SAN fabric.
show fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
FCoE maps.
fc-map
In an FCoE map, configure the FCoE mapped address prefix (FC-MAP) value which is used to identify
FCoE traffic transmitted on the FCoE VLAN for the specified fabric.
S5000
Syntax
fc—map fc-map-value
NPIV Proxy Gateway
1439