Reference Guide

interface
interface
To remove all neighbor entries learned on a specific
interface, enter the keyword interface then the interface
type and slot/port or number information of the interface:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
ipv6 nd mtu
Configure an IPv6 neighbor discovery.
Syntax
ipv6 nd mtu number
Parameters
mtu number Set the MTU advertisement value in Routing Prefix
Advertisement packets. The range is 1280 to 9234.
Defaults none
Command
Modes
INTERFACE
Neighbor Discovery Protocol (NDP)
1399