Reference Guide

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Related
Commands
telnet — telnet to another device.
ip telnet vrf
Configures a TELNET client to use a specific VRF.
S5000
Syntax
ip telnet [vrf vrf-name]
To undo the TELENT client configuration, use the ip telnet [vrf vrf-name]
command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TELENT client.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage
Information
If you configure a TELNET client to use a specific VRF, then you need not explicitly
specify the same VRF during the TELNET client sessions corresponding to that VRF.
Example
Dell(conf)#ip telnet vrf vrf1
Dell(conf)#do telnet 10.10.10.2
Dell(conf)#no ip telnet vrf vrf1
130
Control and Monitoring