Reference Guide

vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN
ID to display the MAC address assigned to the VLAN. The
range is 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
show mac-address-table
Display the MAC address table.
Syntax
show mac-address-table [address mac-address | interface
interface | vlan vlan-id] [aging-time] [dynamic | static]
[count [vlan vlan-id] [interface interface-type [slot [/
port]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses the switch dynamically learns.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only those
MAC addresses specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
aging-time Enter the keyword aging-time to display only aging-time
information.
Layer 2
1293