Reference Guide

show ip bgp ipv6 unicast neighbors
Allows you to view the information exchanged by BGP neighbors.
Syntax
show ip bgp ipv6 unicast neighbors [ipv6-address prefix-length
[advertised-routes | dampened-routes | detail | flap-statistics
| routes]]
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
advertised-
routes
(OPTIONAL) Enter the keywords advertised-routes to
view only the routes the neighbor sent.
dampened-
routes
(OPTIONAL) Enter the keywords dampened-routes to view
information on dampened routes from the BGP neighbor.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to view
flap statistics on the neighbor’s routes.
detail (OPTIONAL) Display detailed neighbor information.
routes (OPTIONAL) Enter the keyword routes to view only the
neighbor’s feasible routes.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.5.1.0 Added the detail option and added information to the
output.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The following describes the show ip bgp ipv6 unicast neighbors
command shown in the Example below.
1186
IPv6 Border Gateway Protocol (IPv6 BGP)