Reference Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
If you do not configure the default-metric command, in addition to the
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-
originate command.
Related
Commands
neighbor default-originate – injects the default route.
show ipv6 mbgproutes
Display the selected IPv6 MBGP route or a summary of all MBGP routes in the table.
Syntax
show ipv6 mbgproutes ipv6-address prefix-length | summary
Parameters
ipv6-address
prefix-length
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
summary Display a summary of RPF routes.
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
IPv6 Border Gateway Protocol (IPv6 BGP)
1177