Reference Guide

Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
The software resolves the network address configured by the network command
with the routes in the main routing table to ensure that the networks are reachable
using non-BGP routes and non-default routes.
Related
Commands
redistribute – redistributes routes into BGP.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected Enter the keyword connected to redistribute routes from
physically connected interfaces.
static Enter the keyword static to redistribute manually
configured routes. These routes are treated as incomplete
routes.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
1176
IPv6 Border Gateway Protocol (IPv6 BGP)