Reference Guide

Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} route-map map-name
{in | out}
To remove the route map, use the no neighbor {ipv6-address | peer-
group-name
} route-map map-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
map-name Enter the name of an established route map. If the Route
map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
IPv6 Border Gateway Protocol (IPv6 BGP)
1173