Reference Guide

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is from 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the software sends a
message. The range is from 1 to 100 percent. The default is
75.
warning-only (OPTIONAL) Enter the keyword warning-only to set the
router to send a log message when the maximum value is
reached. If this parameter is not set, the router stops peering
when the maximum number of prefixes is reached.
Defaults threshold = 75
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor.
Syntax
neighbor {ipv6-address | peer-group-name} next-hop-self
To return to the default setting, use the no neighbor {ipv6-address | peer-
group-name} next-hop-self command.
IPv6 Border Gateway Protocol (IPv6 BGP)
1171