Reference Guide

Defaults IPv6 Unicast
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
After this command is executed, all subsequent commands apply to this address
family. You can exit from this AFI/SAFI to the IPv6 Unicast (the default) family by
entering the exit command and returning to the Router BGP context.
aggregate-address
Summarize a range of prefixes to minimize the number of entries in the routing table.
Syntax
aggregate-address ipv6-address prefix-length [advertise-map
map-name] [as-set] [attribute-map map-name] [summary-only]
[suppress-map map-name]
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the / x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
advertise-map
map-name
(OPTIONAL) Enter the keywords advertise-map then the
name of a configured route map to set filters for advertising
an aggregate route.
as-set (OPTIONAL) Enter the keywords as-set to generate path
attribute information and include it in the aggregate. AS_SET
includes AS_PATH and community information from the
routes included in the aggregated route.
attribute-map
map-name
(OPTIONAL) Enter the keywords attribute-map then the
name of a configured route map to modify attributes of the
aggregate, excluding AS_PATH and NEXT_HOP attributes.
IPv6 Border Gateway Protocol (IPv6 BGP)
1157