Reference Guide

Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you enter the redistribute ospf process-id command without any
other parameters, Dell Networking OS redistributes all OSPF internal routes,
external type 1 routes, and external type 2 routes.
router bgp
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
as-number Enter the AS number. The range is from 1 to 65535.
Defaults Not enabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
1134
IPv6 Border Gateway Protocol (IPv6 BGP)