Reference Guide

Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
redistribute ospf
Redistribute OSPFv3 routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is from 1
to 65535.
match external
{1 | 2}
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify
1 or 2 to
redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to
redistribute OSPFv3 internal routes only.
route-map
map-name
(OPTIONAL) Enter the keywords route-map followed by the
name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to
drop all routes).
IPv6 Border Gateway Protocol (IPv6 BGP)
1133