Reference Guide

Usage
Information
The software resolves the network address configured by the network command
with the routes in the main routing table to ensure that the networks are reachable
using non-BGP routes and non-default routes.
Related
Commands
redistribute – redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Though the system does not generate a route due to backdoor config, there is an
option for injecting/ sourcing a local route in presence of network backdoor config
on a learned route.
1130
IPv6 Border Gateway Protocol (IPv6 BGP)