Reference Guide

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group. All routers in the peer
group receive routes from a route reflector.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {ipv6-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the no neighbor {ipv6-
address
| peer-group-name} shutdown command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
1122
IPv6 Border Gateway Protocol (IPv6 BGP)