Reference Guide

NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
map-name Enter the name of an established route map. If the Route
map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When you apply a route map to outbound routes, only routes that match at least
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor {ipv6-address | peer-group-name} route-reflector-
client
1120
IPv6 Border Gateway Protocol (IPv6 BGP)