Reference Guide

Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
number Enter a number of the AS. The range is from 1 to 65535.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
If the number parameter is the same as the AS number used in the router bgp
command, the remote AS entry in the neighbor is considered an internal BGP peer
entry.
This command creates a peer and the newly created peer is disabled (shutdown).
Related
Commands
router bgp – enters the ROUTER BGP mode and configure routes in an AS.
neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
Syntax
neighbor {ipv6-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ipv6-address | peer-
group-name
} remove-private-as command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
1118
IPv6 Border Gateway Protocol (IPv6 BGP)