Reference Guide

neighbor peer-group (creating group)
Allows you to create a peer group and assign it a name.
Syntax
neighbor peer-group-name peer-group
To delete a peer group, use the no neighbor peer-group-name peer-group
command.
Parameters
peer-group-
name
Enter a text string up to 16 characters long as the name of
the peer group.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
When a peer group is created, it is disabled (shut mode).
Related
Commands
neighbor peer-group (assigning peers) – assigns routers to a peer group.
neighbor remote-as – assigns a indirectly connected AS to a neighbor or peer
group.
neighbor shutdown – disables a peer or peer group.
1116
IPv6 Border Gateway Protocol (IPv6 BGP)