Reference Guide

To disallow and disconnect connections, use the no neighbor {ipv6-address
| peer-group-name} ebgp-multihop [ttl] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the time to live (ttl)
value. The range is from 1 to 255. The default is 255.
Defaults Disabled.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
To prevent loops, the neighbor ebgp-multihop command does not install
default routes of the multihop peer. Networks not directly connected are not
considered valid for best path selection.
neighbor fall-over
Enable or disable fast fall-over for BGP neighbors.
Syntax
neighbor {ipv6-address | peer-group-name} fall-over
To disable, use the no neighbor {ipv6-address | peer-group-name}
fall-over
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
1110
IPv6 Border Gateway Protocol (IPv6 BGP)