Reference Guide

neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-
group-name} allowas-in command.
Parameters
ip-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
number Enter a number of times to allow this neighbor ID to use the
AS path. The range is from 1 to 10.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Related
Commands
bgp four-octet-as-support – enables 4-Byte support for the BGP process.
1106
IPv6 Border Gateway Protocol (IPv6 BGP)