Reference Guide

neighbor advertisement-interval
Set the advertisement interval between BGP neighbors or within a BGP peer group.
Syntax
neighbor {ipv6-address | peer-group-name} advertisement-
interval seconds
To return to the default value, use the no neighbor {ipv6-address | peer-
group-name} advertisement-interval command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group to set the advertisement
interval for all routers in the peer group.
seconds Enter a number as the time interval, in seconds, between
BGP advertisements. The range is from 0 to 600 seconds.
The default is 5 seconds for internal BGP peers and 30
seconds for external BGP peers.
Defaults
• seconds = 5 seconds (internal peers)
• seconds = 30 seconds (external peers)
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
IPv6 Border Gateway Protocol (IPv6 BGP)
1105