Reference Guide

Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
debug ip bgp updates
Allows you to view information about BGP updates.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name | ipv6
unicast [ipv6-address]] updates [in | out | prefix-list prefix-
list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name | ipv6 unicast [ipv6-address]] updates [in |
out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
(OPTIONAL) Enter the keywords peer-group then the name
of the peer group.
ipv6 unicast
[ipv6-address]
(OPTIONAL) Enter the keywords ipv6 unicast, and,
optionally, an ipv6 address.
in (OPTIONAL) Enter the keyword in to view only BGP updates
received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP
updates sent to neighbors.
Command
Modes
EXEC Privilege
IPv6 Border Gateway Protocol (IPv6 BGP)
1099