Reference Guide

Version Description
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage
Information
This command enables soft-reconfiguration for the specified BGP neighbor. BGP
stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name]
keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] keepalives [in | out] command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format. The range is /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
(OPTIONAL) Enter the keywords peer-group followed by
the name of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
IPv6 Border Gateway Protocol (IPv6 BGP)
1097