Reference Guide

debug ip bgp events
Allows you to view information on local BGP state changes and other BGP events.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] events
[in | out]
To disable debugging, use the no debug ip bgp ipv6-address | peer-
group peer-group-name] events command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
Enter the keywords peer-group then the name of the peer
group.
in (OPTIONAL) Enter the keyword in to view only information
on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information
on outbound BGP routes.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
Usage
Information
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
IPv6 Border Gateway Protocol (IPv6 BGP)
1093