Reference Guide

flap-statistics (OPTIONAL) Enter the keywords flap-statistics to clear
all flap statistics belonging to that AS or a specified address
family within that AS.
ipv4 (OPTIONAL) Enter the keyword ipv4 to select options for
that address family.
ipv6 (OPTIONAL) Enter the keyword ipv6 to select options for
that address family.
unicast (OPTIONAL) Enter the keyword unicast to select the
unicast option within the selected address family.
multicast (OPTIONAL) Enter the keyword multicast to select the
multicast option within the selected address family. Multicast
is supported on IPv4 only.
soft (OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session; that
is, BGP Soft Reconfiguration.
NOTE: If you enter clear ip bgp ipv6-address
soft
, both inbound and outbound policies are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound
policies.
out (OPTIONAL) Enter the keyword out to activate only
outbound policies.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.4.2.1 Introduced on the C-Series and S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
1086
IPv6 Border Gateway Protocol (IPv6 BGP)